main logo

3drap Thrustmaster T2pm

I 4 migliori prodotti di aprile 2025
Ultimo aggiornamento: 28 aprile 2025
Thrustmaster
Thrustmaster
Thrustmaster TCA Sidestick Airbus Edition - Replica of the Airbus sidestick - for PC
star

98

QUALITÀ MASSIMA

VEDI SU AMAZON
Amazon.it
#1 VINCITORE

  • 17 pulsanti azione con identificazione in stile “braille”
  • Ispirato all’iconico sidestick Airbus: replica ergonomica in scala 1:1
  • 4 moduli pulsanti intercambiabili per la testa del joystick e 12 pulsanti azione, per innumerevoli possibilità in volo e a terra
  • Manetta con meccanismo integrato per l’inversione di spinta e controllo del timone tramite la rotazione dell’impugnatura del sidestick (con/senza blocco)
  • Tecnologia a sensore magnetico privo di contatto, senza potenziometri, per una durata illimitata e una precisione ottimale
  • 72,90 € SU AMAZON
JAVJIYAI
JAVJIYAI
JAVJIYAI 20mm 2-Phase 4-Wire High Thrust Stepper Electronic Starter Long Linear Screw Slider Position Copper Nut DIY XYZ
star

96

QUALITÀ SUPERIORE

VEDI SU AMAZON
Amazon.it
#2
BIQU
BIQU
BIGTREETECH Manta M8P V2.0 Integrated Control Board 32Bit Running Klipper with CB1, High Speed 3D Printer Motherboard, Compatible TMC5160T Plus,TMC5160,TMC2209,TMC2240 Stepper Driver (Without CB1)
Spedizione gratuita
star

95

QUALITÀ OTTIMA

VEDI SU AMAZON
Amazon.it
#3

  • BIGTREETECH Manta M8P V2.0 Control Board uses 32-bit ARM Cortex-M7 series STM32H723ZET6 main control chip with a core frequency of 550MHz. High efficiency MOSFET for less heat generation
  • The power chip of Manta M8P integrated main control board adopts TPS5450-5A, which supports DC12/24V power input; the output current of this chip is up to 5A, and the peak value can reach 6A, which perfectly supports the power supply of Raspberry-Pi
  • The control board and the core board use BTB connection method, so that other core board solutions other than CM4 can be selected, such as BIGTREETECH CB1. The mainboard reserves the SPI expansion interface for using the Klipper firmware to connect an external acceleration sensor for acceleration compensation
  • The thermistor can select the pull-up resistance value through the jumper, which supports PT1000 without external modules, which is convenient for DIY use; the control board reserves a three-way four-wire fan interface, which can be used to connect a water cooling device
  • The MCU firmware can be upgraded through SD card, or through DFU through Klipper's make flash command; the main board reserves the proximity switch interface, supports NPN and PNP type selection, (24V, 12V, 5V) voltage optional, shared with VFAN6 Voltage selection
  • 109,99 € SU AMAZON
Thrustmaster
Thrustmaster
Thrustmaster ESWAP X2 D-IPPON Module (Gamepad Add-On)
star

92

QUALITÀ OTTIMA

VEDI SU AMAZON
Amazon.it
#4
3drap thrustmaster thrustmaster t2pm 3drap thrustmaster t3pa 3drap thrustmaster t128 3drap thrustmaster tlcm